![]() ![]() usb 5-4: new high-speed USB device number 4 using xhci_hcd usb 5-4: device descriptor read/64, error -110 IPv6: ADDRCONF(NETDEV_CHANGE): enp6s0: link becomes ready igb 0000:06:00.0 enp6s0: igb: enp6s0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX usbcore: registered new interface driver snd-usb-audio usbcore: registered new interface driver uvcvideo ![]() uvcvideo 1-5:1.0: Entity type for entity Camera 1 was not initialized! uvcvideo 1-5:1.0: Entity type for entity Extension 3 was not initialized! uvcvideo 1-5:1.0: Entity type for entity Processing 2 was not initialized! uvcvideo 1-5:1.0: Entity type for entity Extension 7 was not initialized! ![]() uvcvideo 1-5:1.0: Entity type for entity Extension 6 was not initialized! uvcvideo 1-5:1.0: Entity type for entity Extension 4 was not initialized! usb 1-5: set resolution quirk: cval->res = 384 Kernel modules: nouveau, nvidia_drm, nvidiaĭmesg nvidia-modeset: Loading NVIDIA Kernel Mode Setting Driver for UNIX platforms 450.66 Wed Aug 12 19:37: Subsystem: Gigabyte Technology Co., Ltd Device 374c Lspci - k 08:00.0 VGA compatible controller: NVIDIA Corporation GP102 (rev a1) Here are some command outputs that might help, edited for relevant sections: The other monitor is also connected over displayport and is a 1080p monitor. The problem monitor is connected over displayport and is a 2k monitor. I am running the nvidia-450 driver, with a GTX 1080 TI. I have tried all sort of things and read loads of forum posts, but I'm unable to fix this problem. It only happens with one of my monitors, the other monitor is completely unaffected. Every once in a while, seemingly at random, my monitor will go black for a second before refreshing. I'm having some problems with one of the monitors in my dual monitor setup. ![]() I've recently set up my own Arch linux installation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |